|
To perform this modification,
you need, a T610 (obviously), a replacement phone cover,
a small flat bladed screw driver, and a T6 torx
driver.
First remove the back cover, the
battery and the SIM card.
Now remove the top part of the
back cover (the part above the camera). Do this by inserting a small flat
bladed screwdriver between the white and black parts of the phone, and
lever the screwdriver up like a small crowbar on either side of the lens.
The black cover should slide up and off the phone.
Looking at the top of the phone,
remove the small on/off button and put it in safe place. Also remember to
remove the little mirror or rubber grommit from beside the camera lens and
put that in the same safe place as the on/off button. Losing these little
bits will cause you no end of pain as they are not available as spare
parts.
The next bit to remove is a
small green plastic bit of circuit board. It's clipped in and sprung
against some data pins. Again using the flat bladed screwdriver, pop it
off in the direction of the top of the phone.
The whole rear of the phone
should now be exposed. Using a T6 torx screwdriver, unscrew the four small
screws indicated. Put these screws in that safe place.
Once the screws are out, hold
the phone like so, and squeeze gently on the sides and lower edge of the
phone case, the pressure should be enough to create a small gap between
the fascia and the sides, using a fingernail or thin plastic (like a
credit card) make the gap bigger until the fascia pops off. Repeat on the
opposite side of the phone if required.
The fascia should now lift off
completely, exposing the front of the phone.
Push your replacement fascia on
until it clicks into place, and reassemble the phone. if all has gone
well, you should have a T610 that looks as nice as the one shown above. |
