ultima box light os question

[wolfecom]

a question for mark mick or jamie reguards ultimabox ,im gettin this message=please check if you have connected phone directly to usb port!!!because of some incompatibility with windows xp usb hub drivers is possible to get errors if phone is connected in ultimabox light usb port!!!.



ive tried direct usb port on pc and through ultimabox,im running win xp,is ultimabox light compatable with win 98se???? as i use dual boot system,need to know so i can install on win 98

thanks inadvance wolfe

[Mark]

ok,

the popup box is basically telling you to plug the phone directly into the pc usb port, be it a hub or direct , and not into the box

some pc's power output on usb is not strong enough so it may be difficult to connect correctly to the phone if you plug phone cable into ubl box itself.


as for 98, keep away from it with anything usb as 98 struggles to recognise and install drivers for the phones

[wolfecom]

mark,ive tried it direct through the pc usb port like the prog says and with a powered usb hub but im still gettin the same message,ill get back to you on this subject in the morning as ill try it on my laptop on xp

thank m8

[Mark]

omg

its a popup reminding you, it doesnt matter if its plugged there or not it will always remind you

press ok and get on with it

[wolfecom]

ok mark lol im gettin on with it,getting as far as 100% sending ramdld to handset,


then remove cable,power on handset,plug cable
click ok

im powerin on in boot mode



clicked ok prob now is cannot connect to phone Err no: 02010002

fones a v3 with the right boot loader version R374G
thanks m8

[Mark]

the software cant see the phone in boot mode cuss the drivers arnt installled for the phone when connected in this mode


close all software down

reboot pc

dont run soft yet

turn on phone in boot mode and connect it to pc

if windows asks for drivers let it auto search

if it doesnt goto start button/control panel/system/hardare/device manager

look for any yellow question marks and select update driver

then let it auto find them

[wolfecom]

thanks mark,just tried it on xp with an L6

Sending RAMDLD to handset
RAMDLD started ok in handset
Power down handset
Establish connection to handset
FLASH Interface established ok
Read handset bootcore version
Bootcore version on handset: 0200
Try to load backup file
Sending RAMDLD to handset
RAMDLD started ok in handset
Recover handset from blank mode
Power down handset
Handset recovered from blank mode
Easy Skip TP unlock finished ok

works a treat,i had a feelin that it was driver prob as ive tried two diff v3 handsets with the same error,thanks again mark 100% support


wolfe lol ill fetch ya a stick of skeggy rock next time im over flmao

[Mark]

no problem

nice jar of humbugs ;-).......hmmmmmmmm.......humbugs lol

[Mark]

remember...first time you connect a different model like l7, or v3x, u6 etc..you will need to install drivers for it

so best to connect phone in normal mode and install drivers

then connect it in boot mode and install drivers

do this before running moto software and make sure drivers are installed first before unlocking


the next time you connect an l6, it will load drivers automatically now, because windows knows what it is because you have just told it so above

so only have to do this once per handset.


also a tip for you

some phones settings in normal mode can be set to look at memory card rather than phone so put a working sim in that it will accept, goto connection and change to data/fax rather than memory card, then install drivers

you get this with l7,v3x...any phone that takes a memory card...now and then...depends if owner has messed with settings before giving it to you to be unlocked