New 2006 version Universal
digital dual sim
This new dual sim has by far the best compatibility we
have seen so far......
Compatible with the latest Worldwide SIM cards comp V1,
V2 and V3 all supported.
Change the sim on the phones menu
Use 2 sim cards with 1 mobile phone
Switch between 2 cards directly, no need to turn your
phone on and off.
No need to change the cover or back of your phone
Up to now all available dual sim solutions have been
using an analog IC chip.
This new digital dual sim (HyperCard) ,however, it uses
the latest digital IC chip.
Therefore, switching is even more stable and you can
switch sim cards in your phone menu. So you do not have
to turn your phone off and on anymore if you want to
switch sim cards.
You can program a call divert if you want to receive
calls on both lines, change lines quickly when the
signal is weak and save more numbers
You will need to trim your sim cards as the 2 sim cards
will fit inside this holder.
All templates and instructions included.
Compatible with 99% of mobile phones including the
models stated by the other older dual sims on our site
many many more work with this Latest Universal Digital
dual sim as they all support Java applications.
We cannot guarantee compatibility with other PDA's
Not for use with 3G (USIM) SIM cards.
Put the sticker with dashed (printed as below) on the SIM Card.
Follow the lines in red and green and put the
sticker on SIM as above. If correct, it will be same as the picture as below :
Cut the SIM Card using a Stanley knife or sharp
kraft knife carefully around the template as shown in red. You will get a small
SIM Card as below :
Once you have cut both the sim cards slide the metal sleeve off the dual sim and
place the 2 sim cards inside the dual sim ensuring the metal contacts face down.
You may need to use the foam in the dual sim box to apply pressure down on the
sim cards inside the dual sim to ensure a good contact is achieved.
I keep getting “Insert Sim” message.
Usually this message is because the sim cards do not have a good enough contact
which can be solved by.
1) Ensure you use the metal sleeve with the bumps on as this gives the best
2) Clean the sim card contacts with a rubber.
3) Ensure that the sim cards are in the holder square aligning up with the
4) Use the white foam strip inside the dual sim above the sim cards to apply
pressure down on the sim cards therefore improving the contact.
5) You may notice that it is a tight fit putting the dual sim inside the phone's
sim card holder and therefore it may be necesary to put padding outside the dual
sim to ensure the sim cards have a good contact.
XTC 2 CLIP IS HERE
XTC 2 Clip XTC 2 Clip is a new tool that uses JAVA Card Technology to Direct Unlock / S-Off / CID / IMEI Repair some very new HTC phones without Credits